Utility Software 3

How do I create a batch file using the USW?
Please follow the video guideline to get an answer to your question. Create a batch file using DEIF USW 1.1. Log on to the controller/ this will...
Tue, 2 Apr, 2024 at 9:37 AM
How to change operation modes from Utility software?
When connected to the controller from the USW click command icon: Modes can now be changed from USW:
Wed, 21 Dec, 2022 at 9:27 AM
How can I use Trend function in USW to monitor live current readings ?
Please follow the step-by-step instructions in the attached help guide. NOTE: In the help-guide the abbreviation BT is used for bow-thruster.
Mon, 22 Aug, 2022 at 8:56 AM
How to configure/map Modbus & Profibus addresses used in my SCADA system ?
  Modbus Configurator   The Modbus configurator is used to perform a mapping from higher address numbers to the lowest 500 Modbus addresses. The benefit ...
Mon, 22 Aug, 2022 at 8:57 AM
How to flash controller when stuck in boot mode?
Open the newest UWS  Go to file > settings   Write in your IP, in this case / if you are using USB or Serial connection just select ...
Tue, 16 Jan, 2024 at 3:55 PM