AGC-4

FAQ's for customers

How to wire & do the parameter setup for J1939 engine communication ?
Please follow the step-by-step instructions in the attached help guide.
Mon, 22 Aug, 2022 at 8:43 AM
Is it possible to achieve analogue load share between Cummins PCC 3.3 and AGC-4?
Yes it is. Please follow below setup procedure: Paralleling connection and set up: 1. DEIF Controller setup : Menu 6390 in DEIF AGC-4 has the following o...
Mon, 22 Aug, 2022 at 8:43 AM
How to wire & parameterize analogue load share ?
Please follow the step-by-step instructions in the attached help guide.
Mon, 22 Aug, 2022 at 8:45 AM
Is it possible to achieve analogue load sharing between Cummins PCC 3100 and AGC-3/4 ?
Yes, below is the wiring Diagram for the reference.   
Mon, 22 Aug, 2022 at 8:44 AM
AGC-4 and AGC 150 driver issue fix
After a USW update, you can have problems connecting to our AGC-4, AGC-4 Mk II or AGC-150 using USB. You can see the emulated COM port, but when connecting...
Wed, 2 Feb, 2022 at 11:39 AM
I have 4 AGC controllers in my application - how to check if their PM versions are compatible?
The compatibility Check popup is opened by pressing the   button. Then a popup like below is shown:   In this popup the device type, the firmware ve...
Mon, 18 Sep, 2023 at 3:39 PM
How can I see the status of the redundant controller in the Application Supervision window of USW?
Redundancy Some of the devices can be configured for redundancy. In a redundant setup two devices can control e.g. the same genset and breaker so if one fa...
Mon, 22 Aug, 2022 at 1:02 PM
For my application display states Island Mode, but unit is actually in PM Mode when status is read by Modbus - why?
It’s because the “primary” genset mode is Power Management, because of option G5. Then you are also able to run “another” genset mode, etc. “Island mode” th...
Mon, 22 Aug, 2022 at 1:04 PM
Power Management - Load dependent start/stop not working?
Check what Genset mode (CH - 6070) selected in all controllers, set it as Power Management. Cross verify the Load dependent Start / Stop selected unit, ty...
Mon, 22 Aug, 2022 at 1:08 PM
What are the power Management functions?
Power management functions: ● Load-dependent start/stop ● Priority selection ● Manual ● Running hours ● Fuel optimisation ● Ground relay control ● ATS cont...
Mon, 22 Aug, 2022 at 1:10 PM