In case it is desired to have several alarm widgets it is possible to configure alarms so that they belong to a specific group. This way the widget can be configured to show only the alarms added to the alarm group displayed by the widget.
Starting point: Protocol have been created and tags used for triggering alarms is added to the project.
Configure alarms and attach group
It is possible to
- Go to Alarms
- Add alarms
- Attach tags for triggering the alarms
- Open groups by pressing the 2 dot button
- Create groups and check the desired group for each alarm.
Configure active alarms widget
Alarms has now been grouped and now the alarm widget must be configured to show the specific alarms, otherwise it will show all active alarms.
- Drag in the active alarm widget from the Widget Gallery
- Click the alarm widget 3 times to get the right properties available.
- Set Filter 2 to alarm groups (alGroups)
- Lastly the group number of the alarms that should be shown on this specific alarm widget is written
Now activated alarms will only be shown on the alarm widget which has the alarm group configured.